|
[Sponsors] |
January 25, 2017, 04:06 |
hex mesh - advice needed
|
#1 |
New Member
Join Date: Nov 2016
Posts: 5
Rep Power: 9 |
Hey guys,
I am unsuccessfully trying to mesh a body with the Ansys meshing tool (v17.1) by using a MultiZone (hex) element. I watched some tutorials on youtube but could not find a solution for this case. I tried to slice the body in smaller pieces (even smaller than in 2.png) but do not have a real idea of how to slice it to be able to create a full hex meshed body without generating ansys errors. The goemetry is also attached, just in case. I would be thankful for any kind of help! Best regards |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[blockMesh] blockMesh with parametric mesh. Unusual and unseen problem | 13msmemusman | OpenFOAM Meshing & Mesh Conversion | 1 | June 13, 2016 02:25 |
[snappyHexMesh] No layers in a small gap | bobburnquist | OpenFOAM Meshing & Mesh Conversion | 6 | August 26, 2015 09:38 |
[ANSYS Meshing] guidance about refining hex mesh? | hamidciv | ANSYS Meshing & Geometry | 15 | July 27, 2015 02:28 |
[blockMesh] BlockMesh number internal faces and boundary | ynos | OpenFOAM Meshing & Mesh Conversion | 6 | December 13, 2011 05:36 |
fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 11:55 |