 |
 |
 |
|
|
|
[Sponsors] | ||||
August 10, 2015, 18:55
|
Steps to Mirror Mesh
|
#1 |
|
New Member
daniel
Join Date: Sep 2014
Posts: 17
Rep Power: 11  |
Hi all,
I have created a mesh of half of my geometry, but I want the full mesh. So, I try to mirror the entire mesh across the symmetry plane (including the nodes on the symmetry plane). When I run "check mesh" I get single edge errors and nonmanifold vertex errors along the symmetry plane. I try to merge nodes by tolerance, but the errors persist. Can anyone list the steps I should perform in order to properly mirror the mesh? Ive also tried mirroring the mesh without mirroring the nodes on the symmetry plane and I get similar errors. . . Thank you. |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| A variable expressing time steps in UDF? | lcw | FLUENT | 6 | March 28, 2020 03:07 |
| Coupling time duration, Coupling time steps | Jiricbeng | CFX | 0 | April 29, 2015 08:37 |
| creating a chart for a value vs time steps | mhabibnia | CFX | 1 | July 3, 2013 02:45 |
| transient limit is 99,999 time steps? URGENT | azmir | Siemens | 2 | April 15, 2007 22:06 |
| cfx does not give time steps in cfxpost.why.urgent | prakash | CFX | 2 | November 23, 2005 23:06 |
Linear Mode
