|
[Sponsors] |
July 29, 2010, 13:22 |
Offset boundary on surface
|
#1 |
New Member
Etienne
Join Date: May 2010
Posts: 7
Rep Power: 15 |
Hi everybody,
I'm sure that this is a really simple problem, but i dont find the ways to disable the offset option on the surface boundary. I want a tri only surface mesh, but icem create three layer of quad on all the line. The option "All Tri" is activated in the surface global parameter. Thanks |
|
July 30, 2010, 11:59 |
|
#3 |
New Member
Etienne
Join Date: May 2010
Posts: 7
Rep Power: 15 |
You are right.
best regards Etienne |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Gmsh] Error : Self intersecting surface mesh, computing intersections & Error : Impossible | velan | OpenFOAM Meshing & Mesh Conversion | 3 | October 22, 2015 12:05 |
RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 05:05 |
boundary condition at free surface | mike | Fidelity CFD | 3 | June 8, 2006 07:23 |
New topic on same subject - Flow around race car | Tudor Miron | CFX | 15 | April 2, 2004 07:18 |
Velocity on Free Surface Boundary | Lin F.F | Main CFD Forum | 3 | August 4, 2001 12:30 |