[Fabio]

Hello all, i'm new to this package and i'm doing some tutorials starting from the basics. All went well untill i found an exercise where i have to create a 3D curve starting from a coordinates file provided. When i read the file i always get the same "error reading coordinates file" if i try to generate anyway by RMB i go on "show errors and warning" and i can see the error "Duplicate coorinates found in coordinates file" this on line 3

1	1	0	0	0
1	2	15	93.17485624	0
1	3	30	180           0
1	4	45	254.5584412	0
1	5	60	311.7691454	0
1	6	75	347.7332975	0
1	7	90	360           0
1	8	105	347.7332975    0
1	9	120	311.7691454	0
1	10	135	254.5584412	0
1	11	150	180           0
1	12	165	93.17485624	0
1	13	180	4.41053E-14	0
1	14	195	-93.17485624	0
1	15	210	-180          0
1	16	225	-254.5584412	0
1	17	240	-311.7691454	0
1	18	255	-347.73329750	0
1	19	270	-360          0
1	20	285	-347.7332975	0
1	21	300	-311.7691454	0
1	22	315	-254.55844120	0
1	23	330	-180          0
1	24	345	-93.17485624	0
1	25	360	-8.82107E-14	0

someone could give me some advice? I' ve started thinking about how the file is formatted or other strange things, it should open and work, but it isn't.

[Fabio]

A very simple thing that could help me, would be if someone copy/paste the data i provided in a .txt file, and to open it in designmodeler on Ansys, to see if ti gives the same error.
Thanks in advance if someone will do it.