CFD Online Discussion Forums

CFD Online Discussion Forums (
-   ANSYS Meshing & Geometry (
-   -   "Interface" boundary condition in gambit? (

gholamghar August 30, 2010 07:08

"Interface" boundary condition in gambit?
I serached User Guides of gambit but did not found any inforamation about "Interface" boundary type which is in "specify boundary types",can anybody tell me what is this boundary type and when we use it?

Mansureh September 4, 2010 04:49

when you have two fluid zone with non-conformal meshes, or when you want to model MRF or sliding mesh between a rotating and a stationary zone you should specify boundaries as interface.

seyedashraf September 6, 2010 03:25

like modeling a free surface

H_rez September 30, 2016 08:48

Interior B.C. or Interface B.C.
In modelling of mixer in fluent(using gambit as meshing software) should i use interior boundry condition or interface boundry condition between the moving fluid and stationary fluid in MRF model ?

All times are GMT -4. The time now is 08:41.