[ICEM] replay file with different geometry

marting · September 7, 2010, 02:17

Dear all,

I created the geometry of a pump rotor in ProE, copy/paste to get the surface all in one, added this surface to a layer and exported this surface to a tetin file.

The attributed surface mesh in the recorded ICEM-replay file looks like

ic_set_meshing_params surface {ROTOR/2842 ROTOR/2841 ROTOR/2840)

As u can see, the rotor still consists of several surfaces.

Is there a possibility to get the surface mesh attributed to the part ROTOR which shows up in the ICEM model tree and independent from the ROTOR/xy ??

Thank you for your help!
cheers, martin

marting · September 8, 2010, 10:46

got it!

Instead of picking the surfaces of a part separately, one should use the "Part Mesh Setup".

It s the
ic_geo_set_family_params ROTOR no_crv_inf prism 0 emax 9.0 ...

command in the replay file.

martin

September 7, 2010, 02:17	replay file with different geometry	#1
marting New Member Martin Join Date: Sep 2010 Posts: 2 Rep Power: 0	Dear all, I created the geometry of a pump rotor in ProE, copy/paste to get the surface all in one, added this surface to a layer and exported this surface to a tetin file. The attributed surface mesh in the recorded ICEM-replay file looks like ic_set_meshing_params surface {ROTOR/2842 ROTOR/2841 ROTOR/2840) As u can see, the rotor still consists of several surfaces. Is there a possibility to get the surface mesh attributed to the part ROTOR which shows up in the ICEM model tree and independent from the ROTOR/xy ?? Thank you for your help! cheers, martin

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
1.7.x Environment Variables on Linux 10.04	rasma	OpenFOAM Installation	9	July 30, 2010 04:43
openfoam 1.6 on debian etch	romant	OpenFOAM Installation	9	May 6, 2010 02:26
Version 15 on Mac OS X	gschaider	OpenFOAM Installation	113	December 2, 2009 10:23
[Gmsh] Compiling gmshFoam with OpenFOAM-1.5	BlGene	OpenFOAM Meshing & Mesh Conversion	10	August 6, 2009 04:26
Obtain Geometry Data from a Grid File in CFX 10.0	ARJUN	CFX	2	August 17, 2006 07:20

September 8, 2010, 10:46		#2
marting New Member Martin Join Date: Sep 2010 Posts: 2 Rep Power: 0	got it! Instead of picking the surfaces of a part separately, one should use the "Part Mesh Setup". It s the ic_geo_set_family_params ROTOR no_crv_inf prism 0 emax 9.0 ... command in the replay file. martin