 |
 |
 |
|
|
|
[Sponsors] | ||||
September 20, 2010, 22:23
|
an internal error occurre in ICEM
|
#1 |
|
New Member
Qiulan Zeng
Join Date: Sep 2010
Posts: 18
Rep Power: 15  |
Hi, everybody. Here is my problem when i tried to mesh the surface. When i finished compute surface mesh using patch dependent method I checked and found that two curves forming a sharp angle. Knowing that the two curves have no influence on connectivity between surfaces, so I wanted to delete them. By this time, a spread sheet was popped up saying "an internal error has occured: syntax error in expression 'emethod':variable references require preceding$...." What does this mean? Why it happens every time I perform this practice? What can I do then?
Many thanks! |
|
|
|
|
|
September 21, 2010, 11:06
|
Techsupp@ansys.com
|
#2 |
|
Senior Member
Simon Pereira
Join Date: Mar 2009
Location: Ann Arbor, MI
Posts: 2,663
Blog Entries: 1
Rep Power: 47 |
I can't tell from here...
I suggest that any failures be reported to TechSupp@Ansys.com Ideally you can include the case with instructions so they can reproduce it and get the same crash... If we can crash it, we can fix it. Best regards, Simon |
|
|
|
|
|
|
September 22, 2010, 10:14
|
|
#3 |
|
New Member
Qiulan Zeng
Join Date: Sep 2010
Posts: 18
Rep Power: 15 |
Dear Semon,
I have reported the failures to TechSupp@Ansys.com. Thank you so much! Best wishes! Qiulan Zeng |
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ICEM] ICEM CFD internal Wall by using structured Grid | challenger85 | ANSYS Meshing & Geometry | 17 | January 26, 2017 13:04 |
| ICEM CFD 5.0 (Hexa) - Internal Wall/Thin Surface | James Date | CFX | 3 | August 10, 2012 04:47 |
| ICEM CFD - minor internal error, number of nodes don't match | Anorky | ANSYS Meshing & Geometry | 0 | June 4, 2009 10:41 |
| Design Modeler to ICEM..... | Joe | CFX | 0 | January 24, 2008 03:39 |
| ICEM CFD 5.0 (Tetra) - Internal Wall/Thin Surface | James Date | CFX | 3 | December 24, 2004 07:41 |
Linear Mode
