 |
 |
 |
|
|
|
[Sponsors] | ||||
October 15, 2010, 22:33
|
problems with gambit tools turbo
|
#1 |
|
New Member
qx
Join Date: Oct 2010
Posts: 3
Rep Power: 15  |
hi ,all
I am encountering a problem with turbo in the gambit. In the turbo, it requires to specify a slide virtual vertex ,but i don't know how to calculate it . i have read the gambit help, but it doesn't explain it . Another problem with turbo is that : can it be used to mesh multistage centrifugal compressor? if it can be used to mesh it , then how should i set up the model? Any suggestion or ideas would be appreciated. Thank you very much qxtxdy |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Meshing problems using Gambit | Vianney | FLUENT | 4 | May 30, 2009 03:45 |
| problems with STEP file | ertan | FLUENT | 0 | August 1, 2008 17:51 |
| Lobe pump + Turbo in Gambit | Hari Kamaraju | FLUENT | 1 | December 13, 2007 03:34 |
| Gambit Meshing Problems | Francesco B | FLUENT | 2 | September 30, 2005 04:28 |
| GAMBIT and Turbomachinery | tom | Main CFD Forum | 6 | October 21, 1999 09:50 |
Linear Mode
