MattTA |
November 3, 2010 23:34 |
Makeing a square to round loft in workbench DM
So as it says, I am trying to loft from a square to a circle in design modeler and I get the issue of not having the same number of sides. I'm obviously a bit of a novice and have never tried making complicated shapes like this before. I'm sure I could make this in Solid works and already have though I would imagine theres a way to do this in ansys also. I have done some searches and look through some DM documentation but have not been able to figure it out. Any help is appreciated.
|