Multi Zone with ICEM
Hi, guys
I want to use MRF method to simulate a centrifugal pump, I used ICEM to mesh its geometry, According to fluent guide(Using Multiple Rotating Reference Frames) I made 3 zones and meshed them seperately, But the problem is that according to the guide after reading the mesh we will have shadows ( the wall between two intrior) and then we should change their type to interior, but i dont have any shadow now!!! |
I am not an expert at this, but if you imported them as separate files, you may just have two walls instead of a wall and its shadow. I think you can still turn those walls into "interior".
|
|
All times are GMT -4. The time now is 00:12. |