Not create wall.shadow (couple)
Dear all
I would like to simulate conjugate heat transfer in Fluent, and I make the mesh by using GAMBIT. My model consists of solid and fluid zone , when I imports the mesh into Fluent why the wall shadow is not generated? cold anyone help me? |
If you haven't split the volume and maintained connectivity, this can often happen. Check to ensure the volumes are connected, then give it another shot!
If this doesn't work, post a journal if possible and we'll see if we can help. ComputerGuy |
Quote:
My work does not work yet, I need your help please. I'd like you to check where it is wrong but I can not attach file on this Reply (I don' know how to do). Can I send it to you by email and can I have you email ? my email is: nueng_en257@hotmail.com thank you nuengao |
Check your email. Problem fixed.
ComputerGuy |
Quote:
I already got it. Thank you very much |
I have the same problem
Hello Computerguy,
I have a very similar problem. I drew my mesh in gambit and read it into fluent 15 and then I face two problems: 1) I cant check my wall to be coupled 2) It seems like Fluent do not understand the interface between my fluid and solid Case desciption: I have heat transfer from the surrounding gas into in the two pipes. The fin and pipes are solids. I want to specify a temperature on the inside of the pipes and an inlet temperature for the gas. I hope you want/can help me with my problem. Simon |
All times are GMT -4. The time now is 14:55. |