|
[Sponsors] |
January 31, 2011, 10:58 |
create edge from points
|
#1 |
New Member
fatma
Join Date: Jan 2011
Posts: 9
Rep Power: 15 |
Hello,
how to create an edge from three points on DM? On Gambit: Code:
edge create center "c1" major "c2" onedge "c3" start 0 end 360 ellipse |
|
January 31, 2011, 18:25 |
|
#2 |
New Member
Ali
Join Date: May 2010
Posts: 11
Rep Power: 15 |
I'm fairly new to DesignModeler, but from what I understand you can insert the points manually and then use the 'Line From Points' option and create a line between them.
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Meshing a Sphere | Ajay | FLUENT | 10 | September 3, 2016 14:18 |
Actuator disk model | audrich | FLUENT | 0 | September 21, 2009 07:06 |
Where's the singularity/mesh flaw? | audrich | FLUENT | 3 | August 4, 2009 01:07 |
[blockMesh] BlockMeshmergePatchPairs | hjasak | OpenFOAM Meshing & Mesh Conversion | 11 | August 15, 2008 07:36 |
fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 11:55 |