[DesignModeler] Static Ansys (Ansys)

Malyahya · February 4, 2011, 08:23

Hi, I am simulating centrifugal compressor flow and vibration, I finished the aerodynamic part, but when i tried to simulate the structural part using (static structural ANSYS), i got an error while updating model, which says (unable to attach geometry).
Appreciate any advise.

PSYMN · February 5, 2011, 15:02

That is a good question for Tech support. They may want to see your model. Academics also qualify for tech support. Send your model to Techsupp@ansys.com or go in thru the customer portal (faster).

Malyahya · February 5, 2011, 19:25

Thanks, for your advise, I managed to solve the problem by editing the model in the Design Modeler (although a tick mark exits) and saving it again (normally not required).

February 4, 2011, 08:23	Static Ansys (Ansys)	#1
Malyahya New Member Mohamed Join Date: Feb 2011 Posts: 4 Rep Power: 16	Hi, I am simulating centrifugal compressor flow and vibration, I finished the aerodynamic part, but when i tried to simulate the structural part using (static structural ANSYS), i got an error while updating model, which says (unable to attach geometry). Appreciate any advise.

February 5, 2011, 15:02	Time for Tech Support?	#2
PSYMN Senior Member Simon Pereira Join Date: Mar 2009 Location: Ann Arbor, MI Posts: 2,663 Blog Entries: 1 Rep Power: 48	That is a good question for Tech support. They may want to see your model. Academics also qualify for tech support. Send your model to Techsupp@ansys.com or go in thru the customer portal (faster).

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
error: uninitialized local variable 't' used	MASOUD	Fluent UDF and Scheme Programming	5	October 17, 2016 05:24
UDF issue	MASOUD	Fluent UDF and Scheme Programming	14	December 6, 2012 14:39
fprint problem	MASOUD	Fluent UDF and Scheme Programming	5	October 30, 2011 17:08
defining a term for a domain using DEFINE_ADJUST	MASOUD	Fluent UDF and Scheme Programming	1	September 24, 2010 06:08
enum	MASOUD	Fluent UDF and Scheme Programming	0	June 5, 2010 01:49

February 5, 2011, 19:25		#3
Malyahya New Member Mohamed Join Date: Feb 2011 Posts: 4 Rep Power: 16	Thanks, for your advise, I managed to solve the problem by editing the model in the Design Modeler (although a tick mark exits) and saving it again (normally not required).