Cut body with surface in DM
Dear All,
could you tell me how to split a imported body into 2 with a surface? in Design Modeler? Also, how can I split a body to 2 volumes so later they can be treated separately in CFX? Thanks a lot in advance for any help! |
Did you ever find a solution to this problem?
|
freeze
Quote:
yes I fogured it out myself. As far as I remember freeze was the key for doing the split. |
1 Attachment(s)
hello la7low
I am a beginner, I have a geometry with two pipes connected at 90. I have to cut them at the elbow and mesh the elbow with tets and then sweep it along with linear sections but I do not understand how I can do it. My drawing is attached. can you please describe the procedure step by step how you cut the geometry and sweep it linearly. Regards |
All times are GMT -4. The time now is 14:57. |