|
[Sponsors] |
February 11, 2011, 08:38 |
Cut body with surface in DM
|
#1 |
Member
Join Date: May 2010
Posts: 44
Rep Power: 16 |
Dear All,
could you tell me how to split a imported body into 2 with a surface? in Design Modeler? Also, how can I split a body to 2 volumes so later they can be treated separately in CFX? Thanks a lot in advance for any help! |
|
April 18, 2011, 10:41 |
|
#2 |
New Member
Andrew
Join Date: Nov 2010
Posts: 12
Rep Power: 15 |
Did you ever find a solution to this problem?
|
|
March 1, 2013, 10:44 |
|
#4 |
Senior Member
starter
Join Date: Sep 2012
Posts: 125
Rep Power: 16 |
hello la7low
I am a beginner, I have a geometry with two pipes connected at 90. I have to cut them at the elbow and mesh the elbow with tets and then sweep it along with linear sections but I do not understand how I can do it. My drawing is attached. can you please describe the procedure step by step how you cut the geometry and sweep it linearly. Regards |
|
Tags |
split, volume |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
mass flow rate on the Iso-clip surface & interior | Sunil Gupta | FLUENT | 0 | April 22, 2008 10:29 |
creating solid from car body surface data | Mehmet Yilmaz | FLUENT | 1 | January 16, 2008 07:57 |
user surface in post | xinzhangabc | CFX | 0 | February 24, 2005 07:29 |
Flame Surface Density. | Burn Ing | Main CFD Forum | 3 | December 5, 2004 18:12 |
gravitational force for free surface flow | Jongtae Kim | Main CFD Forum | 1 | July 2, 2000 12:57 |