|
[Sponsors] |
[DesignModeler] How to create a pipe like this? |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
February 21, 2011, 22:43 |
How to create a pipe like this?
|
#1 |
New Member
Da Yanjing
Join Date: Feb 2011
Posts: 2
Rep Power: 0 |
pipe with hole inside.pdf
Hi, everybody! I want to create a single pipe, along its axis, a baffle (no thickness) with a hole is installed, how to create this geometry in DesignModeler? Thank you very much for your kind help. Best regards, Dyanjing |
|
February 23, 2011, 06:58 |
|
#2 |
New Member
Da Yanjing
Join Date: Feb 2011
Posts: 2
Rep Power: 0 |
no answers? Maybe it is too difficult to create by DesignModeler.
|
|
March 3, 2011, 03:46 |
|
#3 |
Senior Member
Ugly Kid Joe
Join Date: Aug 2010
Posts: 193
Rep Power: 15 |
Is it 3-D ???????? Wats so difficult abt it ???????
|
|
March 3, 2011, 03:47 |
|
#4 |
Senior Member
Ugly Kid Joe
Join Date: Aug 2010
Posts: 193
Rep Power: 15 |
I can help u out in ICEM if u want ???
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
create patch to obtain annular pipe | nikwin | OpenFOAM | 0 | January 4, 2010 02:56 |
Actuator disk model | audrich | FLUENT | 0 | September 21, 2009 07:06 |
Where's the singularity/mesh flaw? | audrich | FLUENT | 3 | August 4, 2009 01:07 |
fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 11:55 |
Terrible Mistake In Fluid Dynamics History | Abhi | Main CFD Forum | 12 | July 8, 2002 09:11 |