|
[Sponsors] |
February 24, 2011, 10:16 |
Wind tunnel hexa meshing in ICEM CFD 12.1
|
#1 |
New Member
Matheus Guzella
Join Date: Jun 2009
Posts: 12
Rep Power: 17 |
Hello,
I'm using ICEM CFD 12.1 for meshing a wind tunnel with hexa elements.. but I don't know (I don't have much experience with hexa meshing) how to make to correct associations, since I'm using only half of the model (as can be checked on the file attached).. I'm meshing this model for a project on my university, I tried to see the tutorial but I couldn't solve this problem.. Best Regards, Matheus Guzella |
|
March 14, 2011, 17:14 |
|
#2 |
Senior Member
Simon Pereira
Join Date: Mar 2009
Location: Ann Arbor, MI
Posts: 2,663
Blog Entries: 1
Rep Power: 47 |
If you took the section 45 degrees from this one, it would have 4 good corners and would be much easier to hexa mesh than this triangular section...
However, you can still handle this triangular section with a quarter ogrid (aka Ygrid) or wedge (collapsed hexa) topology... |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
inflation layers for hexa mesh using icem cfd | Apple | CFX | 4 | January 6, 2012 01:12 |
simulate wind tunnel and meshing....need some help | ACER | FLUENT | 0 | December 27, 2010 17:02 |
Hexa ICEM CFD | Amit | CFX | 3 | July 28, 2008 19:48 |
Hexa Meshing with ICEM & CFX | Matias | CFX | 2 | May 9, 2007 20:57 |
Comparing wind tunnel tests costs with CFD | Freeman | Main CFD Forum | 9 | January 30, 2006 09:02 |