CFD Online Discussion Forums

CFD Online Discussion Forums (
-   ANSYS Meshing & Geometry (
-   -   [ANSYS Meshing] meshing help (

KateyMT February 28, 2011 17:34

meshing help
3 Attachment(s)
hello. i'm looking for some tips/ideas for creating a mesh for the attached image. it is a Steeppass fishway that i will use to run a VOF open channel model. when i just let the ANSYS mesher do its thing (automatic patch conforming/sweeping)i have trouble with skewness. the channel is ~20 ft long, the cross section is ~18" wide by 24" deep, and the baffles are .25" thick. let me know if any additional information is needed to make suggestions for how to proceed.

Attachment 6703

Attachment 6704

Attachment 6705

All times are GMT -4. The time now is 11:55.