|
[Sponsors] |
March 22, 2011, 05:14 |
Extrude face error message
|
#1 |
Senior Member
AB
Join Date: Sep 2009
Location: France
Posts: 323
Rep Power: 21 |
Hi all,
When I try to extrude the face of an o-grid face along a curve, the following error message appeared in the terminal : Extrusion of faces failed while executing "hexlib_interface__1759 extrude_faces 1 { 184 186 185 187 } FLUID 1.0 -end -0.39004332 0.0053771459 0.050303191 -curve crv.12 -twist 0 -nsub 1 -type no..." ("eval" body line 1) invoked from within "eval $hexlib extrude_faces $args" (procedure "ic_hex_extrude_faces" line 4) invoked from within "ic_hex_extrude_faces 1 { 184 186 185 187 } FLUID 1.0 -end -0.39004332 0.0053771459 0.050303191 -curve crv.12 -twist 0 -nsub 1 -type normal WALL:.0 WAL..." invoked from within "batch_interp eval ic_hex_extrude_faces $args" Extrusion of faces failed I'm using ICEM CFD 12.1 on Linux (64 bits). Thanks |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Netgen] Import netgen mesh to OpenFOAM | hsieh | OpenFOAM Meshing & Mesh Conversion | 32 | September 13, 2011 05:50 |
[Gmsh] Cannot get the right mesh from gmsh | JinBiao | OpenFOAM Meshing & Mesh Conversion | 2 | August 31, 2010 04:51 |
[blockMesh] BlockMeshmergePatchPairs | hjasak | OpenFOAM Meshing & Mesh Conversion | 11 | August 15, 2008 07:36 |
fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 11:55 |
[blockMesh] Axisymmetrical mesh | Rasmus Gjesing (Gjesing) | OpenFOAM Meshing & Mesh Conversion | 10 | April 2, 2007 14:00 |