Tgrid makes FLUENT contours messed up??

me3840 · April 4, 2011, 19:50

Hey guys,

I just got a copy of Tgrid 64bit (ANSYS 13), but when I mesh things with it and run them, then plot the contours in FLUENT12, the body of whatever I'm modeling isn't "solid" - that is, you can see the part of the car facing you and the part that should be hidden at the same time? This doesn't occur when I use Tgrid 32bit (from ANSYS 12), but then I'm limited to 4GB of memory to make meshes!

Any advice?

udayrg · May 13, 2011, 07:26

I feel the problem is not with the mesh. The problem would be with the graphic's Setting in Fluent.

April 4, 2011, 19:50	Tgrid makes FLUENT contours messed up??	#1
me3840 Senior Member Join Date: Nov 2010 Location: USA Posts: 1,232 Rep Power: 24	Hey guys, I just got a copy of Tgrid 64bit (ANSYS 13), but when I mesh things with it and run them, then plot the contours in FLUENT12, the body of whatever I'm modeling isn't "solid" - that is, you can see the part of the car facing you and the part that should be hidden at the same time? This doesn't occur when I use Tgrid 32bit (from ANSYS 12), but then I'm limited to 4GB of memory to make meshes! Any advice?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Stopping a Fluent batch job AND saving the data! Possible?	Volker Pawlik	FLUENT	13	December 28, 2020 04:16
Contours of density gradient in fluent 5?	Ricky Wong	FLUENT	3	May 19, 2015 01:39
On Bug of Fluent 12.0	lzgwhy	FLUENT	0	August 26, 2009 06:41
Fluent Vs CFX, density and pressure	Omer	CFX	9	June 28, 2007 04:13
Advanced Turbulence Modeling in Fluent, Realizable k-epsilon Model	Jonas Larsson	FLUENT	5	March 13, 2000 03:27

May 13, 2011, 07:26		#2
udayrg Member Join Date: Mar 2009 Posts: 32 Rep Power: 17	I feel the problem is not with the mesh. The problem would be with the graphic's Setting in Fluent.