|
[Sponsors] |
May 4, 2011, 13:07 |
hotkeys
|
#1 |
New Member
chubb87
Join Date: May 2011
Posts: 21
Rep Power: 14 |
Hi,
I am using ICEM and have found the hotkeys in the documentation. But in a tutorial video I noticed there have to be hotkeys I didn't find in the documentation: in the selection modus, e.g. when associating edge to curve: There are two buttons "select edge" and "select compcurve", It would be great if I could use hotkeys for these, especially because often I have to associate many curves consecutively. There also seems to exist a hotkey for "apply". Thank you in advance. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Scaling Mesh from Millimetres to Metres | Josh | ANSYS Meshing & Geometry | 8 | April 28, 2014 10:30 |
[ICEM] what causes this bug in ICEMCFD? | snailstb | ANSYS Meshing & Geometry | 6 | March 1, 2011 10:47 |