|May 4, 2011, 13:07||
Join Date: May 2011
Posts: 20Rep Power: 7
I am using ICEM and have found the hotkeys in the documentation.
But in a tutorial video I noticed there have to be hotkeys I didn't find in the documentation:
in the selection modus, e.g. when associating edge to curve:
There are two buttons "select edge" and "select compcurve",
It would be great if I could use hotkeys for these, especially because often I have to associate many curves consecutively. There also seems to exist a hotkey for "apply".
Thank you in advance.
|Thread||Thread Starter||Forum||Replies||Last Post|
|[ICEM] Scaling Mesh from Millimetres to Metres||Josh||ANSYS Meshing & Geometry||8||April 28, 2014 10:30|
|[ICEM] what causes this bug in ICEMCFD?||snailstb||ANSYS Meshing & Geometry||6||March 1, 2011 11:47|