 |
 |
 |
|
|
|
[Sponsors] | ||||
May 25, 2011, 19:48
|
show command
|
#1 |
|
New Member
Join Date: May 2011
Posts: 1
Rep Power: 0  |
I am trying to kill elements in Ansys Workbench, Windows, simulation is descibed in command line, when I try to plot by plnsol,temp it says that
*** NOTE *** Display device has not yet been specified with the /SHOW command. Display commands ignored. I guess i should give the device type by /show, <device type> , any idea what would it be? under unix it's x11, x3d, but on windows? I would be thankfull for any kind of help. Cheers Peter |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| OpenFOAM 1.7.1 installation problem on OpenSUSE 11.3 | flakid | OpenFOAM Installation | 16 | December 28, 2010 08:48 |
| Installation OF1.5-dev | ttdtud | OpenFOAM Installation | 46 | May 5, 2009 02:32 |
| OpenFOAM15 installables are incomplete problem with paraFoam | tryingof | OpenFOAM Bugs | 17 | December 7, 2008 04:41 |
| Regarding FoamX running Kindly help out | hariya03 | OpenFOAM Pre-Processing | 0 | April 18, 2008 04:26 |
| fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 11:55 |
Linear Mode
