|May 26, 2011, 22:25||
the ball-to-wall contact area
Join Date: Apr 2011
Posts: 3Rep Power: 7
hello,In order to avoid bad mesh quality at ball-to-wall contact point,area-contacts between balls and walls were applied.However,I found that the mesh quality at area contact was not easy to be controlled. I used tetra mesh and octree method.I wonder whther i need to creat structured mesh for this geometry?
I will be very grateful for any suggestions。
Last edited by shanshanbu; May 26, 2011 at 23:27.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Dynamic contact angle||rmousavibt||Fluent UDF and Scheme Programming||11||January 6, 2017 16:45|
|Superlinear speedup in OpenFOAM 13||msrinath80||OpenFOAM Running, Solving & CFD||18||March 3, 2015 06:36|
|UDF to Access Wall Normal Concentration Gradient||Daniel Tanner||Fluent UDF and Scheme Programming||4||February 18, 2015 15:35|
|Tomiyama wall lubrication force||Edy||OpenFOAM||10||December 13, 2010 12:41|
|Wall functions||tutlhino||OpenFOAM Pre-Processing||0||July 2, 2007 05:04|