Fail to create skin from imported spline (.stp) into DesignModeler -- CFD Online Discussion Forums

June 13, 2011, 01:19

Fail to create skin from imported spline (.stp) into DesignModeler

chg

New Member

Join Date: Apr 2011

Posts: 11

Rep Power: 15

Hi,

I have successfully imported spline from .stp file into DesignModeler (attached pic) via import external geometry file. However, I couldn't find the next step to turn these spline into lines for Skin/loft function. Any suggestion would be much appreciated.

Attached Images

spline.jpg (83.2 KB, 5 views)

June 13, 2011, 02:52		#2
chg New Member Join Date: Apr 2011 Posts: 11 Rep Power: 15	Found the answer in the old thread. Thank you for your attention.

« Previous Thread | Next Thread »

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Spline in DesignModeler?	Edu-R	ANSYS Meshing & Geometry	1	April 4, 2010 18:04
Actuator disk model	audrich	FLUENT	0	September 21, 2009 07:06
How to create a variable-pitch helical sweep in Designmodeler (v11.0)	dgasperi	ANSYS Meshing & Geometry	0	August 13, 2009 13:11
Where's the singularity/mesh flaw?	audrich	FLUENT	3	August 4, 2009 01:07
fluent add additional zones for the mesh file	SSL	FLUENT	2	January 26, 2008 11:55

All times are GMT -4. The time now is 15:20.