CFD Online Discussion Forums

CFD Online Discussion Forums (https://www.cfd-online.com/Forums/)
-   ANSYS Meshing & Geometry (https://www.cfd-online.com/Forums/ansys-meshing/)
-   -   [ICEM] mesh trailing edge wedge (https://www.cfd-online.com/Forums/ansys-meshing/89774-mesh-trailing-edge-wedge.html)

josip76 June 22, 2011 05:17

mesh trailing edge wedge
 
hi im hoping someone could take a look at my mesh of a transonic airfoil with a trailing edge wedge and tell me what they thought. If there maybee is a better way to capture the geometry around the wedge? I used a structured hex mesh.

pic of mesh around trailing edge wedge
http://dl.dropbox.com/u/29394155/tail.JPG


and heres a pic of the blocking structure around the airfoil if ur interested to see this
http://dl.dropbox.com/u/29394155/whole.JPG

Thanks for any input

jeevankumarb June 22, 2011 06:08

Your blocking and the meshing is perfect only there is cell jump near the TTE, just correct the bunching near the tte.

josip76 June 22, 2011 06:40

hey thanks for ur reply, ya i'll match the edges in the horizontal direction along the flat trailing edge surfce and maybee add some more nodes there. Thanks for ur input

nvtrieu August 28, 2013 21:02

Hi,

Could you show me the full domain and the final mesh?
what is the y+ value?

Thank you very much.

cesarcg August 31, 2013 15:59

I think that you would control the cells behavior around the wedge trailing edge if you add a cut in the pressure side of the blocking as close as possible to the 6th point from right to left. Then adjust the edge of the new blocking in order to increase the orthogonality of cells near this area.

Regards.

diamondx September 1, 2013 11:12

The thread is two years old...

cesarcg September 1, 2013 12:31

Quote:

Originally Posted by diamondx (Post 449214)
The thread is two years old...

:D I did not notice that haha... :D


All times are GMT -4. The time now is 17:53.