CFD Online Discussion Forums

CFD Online Discussion Forums (
-   ANSYS Meshing & Geometry (
-   -   [ANSYS Meshing] Blocking of a static mixer (

donkey86 July 6, 2011 03:20

Blocking of a static mixer
1 Attachment(s)
Hi there,

I have a question regarding the blocking of a static mixer. In the pipe I have 9 mixing elements protruding to the inside. Now I have no idea how to block this parts.
Using the Manual, I figured out to put blocks around these elements, but I am not sure about the collapsing tool and how to use it. May you guys have some good ideas or advices on how to procede.
Thank you very much for the help!

All times are GMT -4. The time now is 04:54.