[GAMBIT] Unable to create .msh file due high order elements on meshed face error

Ty@flent · August 27, 2011, 11:38

Sponsored Links

Dear all

In gambit, after meshing and specifying boundaries, once i try to export the 2D file to fluent, the following error is generated

"Face Face 1 has higher order elements and cannot be exported to Fluent 5 format"

I have tried different mesh types and sizes but could not get rid of the error

The file pertains to an aerofoil created by joining 49 x,y points through NURB curve in gambit

Thanking in anticipation, please help

-mAx- · August 29, 2011, 02:02

did you change something in Set Face Element Type (surface/mesh)?
Default should be 4 node for quadrilateral and 3 node for triangle

Ty@flent · August 29, 2011, 16:05

Yes. This was precisely the reason. The settings were found altered to higher values and restoring them to default enabled the mesh to be exported successfully to fluent by writing the .msh file.
Hats off to your judgement and many many thanks

August 27, 2011, 11:38	Unable to create .msh file due high order elements on meshed face error	#1
Ty@flent New Member Join Date: Aug 2011 Posts: 2 Rep Power: 0	Sponsored Links Dear all In gambit, after meshing and specifying boundaries, once i try to export the 2D file to fluent, the following error is generated "Face Face 1 has higher order elements and cannot be exported to Fluent 5 format" I have tried different mesh types and sizes but could not get rid of the error The file pertains to an aerofoil created by joining 49 x,y points through NURB curve in gambit Thanking in anticipation, please help

August 29, 2011, 02:02		#2
-mAx- Super Moderator Maxime Perelli Join Date: Mar 2009 Location: Switzerland Posts: 3,232 Rep Power: 34	did you change something in Set Face Element Type (surface/mesh)? Default should be 4 node for quadrilateral and 3 node for triangle Shayan, Ty@flent and naveensdas like this. __________________ In memory of my friend Hervé: CFD engineer & freerider

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
GroovyBC the dynamic cousin of funkySetFields that lives on the suburb of the mesh	gschaider	OpenFOAM	300	October 29, 2014 19:00
Version 15 on Mac OS X	gschaider	OpenFOAM Installation	120	December 2, 2009 11:23
fluent add additional zones for the mesh file	SSL	FLUENT	2	January 26, 2008 12:55
Compiling problems with hello worldC	fw407	OpenFOAM Installation	21	January 6, 2008 18:38
DecomposePar links against liblamso0 with OpenMPI	jens_klostermann	OpenFOAM Bugs	11	June 28, 2007 17:51

August 29, 2011, 16:05		#3
Ty@flent New Member Join Date: Aug 2011 Posts: 2 Rep Power: 0	Yes. This was precisely the reason. The settings were found altered to higher values and restoring them to default enabled the mesh to be exported successfully to fluent by writing the .msh file. Hats off to your judgement and many many thanks