|
[Sponsors] |
September 2, 2011, 12:29 |
ICEM crashing before meshing
|
#1 |
New Member
mehcaecfd
Join Date: Mar 2009
Location: Bangalore
Posts: 3
Rep Power: 17 |
Hi,
I am facing a strange problem in ICEM CFD. When I try to start the mesh by Compute mesh for one of complex geometry, ICEM initially goes fine. After some time, it crahses without giving any mesh ( It does not create any *.uns file). I obserevd that, when it tries to split edges at surfaces or somtimes at trilateral round at curve during computing mesh, It crahes. I appreciate, if any body can share their experience, if they would have faced same problem. As far as my my geometry is considered, it is almost without any holes. Is it due to huge no of curves or any deformed surfaces. For the same geometry I was able to perform mesh sometime back, but now I have added few parts, and not able to do the mesh. I would request any experts to give their opinion. One more thing, I would like to add is, when I increase scale factor too much, then I get the mesh, but that is with many holes, which is not acceptable. Thanks, Mehul |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] complex 2D meshing on ICEM | kassab | ANSYS Meshing & Geometry | 26 | April 14, 2014 21:02 |
Meshing a Mixing Plane using ICEM | Will Anderson | FLUENT | 0 | November 6, 2010 17:08 |
[ICEM] ICEM meshing problem | xyq102296 | ANSYS Meshing & Geometry | 6 | October 28, 2010 10:09 |
[ICEM] Need help in ICEM CFD Mapped Meshing | falconf16 | ANSYS Meshing & Geometry | 3 | February 19, 2010 14:21 |
Missing tets along line when meshing with ICEM CFD | Georges P. Côté | CFX | 6 | March 23, 2006 00:34 |