|
[Sponsors] |
September 13, 2011, 04:07 |
cut a face on a volume (real)
|
#1 |
Member
leila
Join Date: Jul 2011
Posts: 35
Rep Power: 14 |
hi max
the pic attached is a spray dryer chamber that hot gas enters it from a ring hole on top of it. I want to creat a ring enterance on the top. is it clear? |
|
September 13, 2011, 05:35 |
|
#2 |
Super Moderator
Maxime Perelli
Join Date: Mar 2009
Location: Switzerland
Posts: 3,297
Rep Power: 41 |
do you just want to isolate an annular face on the top face?
__________________
In memory of my friend Hervé: CFD engineer & freerider |
|
September 13, 2011, 06:54 |
|
#3 |
Member
leila
Join Date: Jul 2011
Posts: 35
Rep Power: 14 |
no. the annular face must be a part of the total volume and it must be meshed. I want to enter air from it in the chamber.
|
|
September 13, 2011, 06:58 |
|
#4 |
Super Moderator
Maxime Perelli
Join Date: Mar 2009
Location: Switzerland
Posts: 3,297
Rep Power: 41 |
so you want your top surface divided with a circle, which will describe your annular, right?
__________________
In memory of my friend Hervé: CFD engineer & freerider |
|
September 13, 2011, 08:00 |
|
#5 |
Member
leila
Join Date: Jul 2011
Posts: 35
Rep Power: 14 |
yes. on the top surface there is a ring from it hot gas enters the chamber.
|
|
September 13, 2011, 08:10 |
|
#6 |
Super Moderator
Maxime Perelli
Join Date: Mar 2009
Location: Switzerland
Posts: 3,297
Rep Power: 41 |
create the circle (edge), move it at it right position, and then split top surface with circle
__________________
In memory of my friend Hervé: CFD engineer & freerider |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
how to set periodic boundary conditions | Ganesh | FLUENT | 15 | November 18, 2020 07:09 |
channelFoam for a 3D pipe | AlmostSurelyRob | OpenFOAM | 3 | June 24, 2011 14:06 |
[Gmsh] Import problem | ARC | OpenFOAM Meshing & Mesh Conversion | 0 | February 27, 2010 11:56 |
gmsh2ToFoam | sarajags_89 | OpenFOAM | 0 | November 24, 2009 23:50 |
[GAMBIT] Difference between real & virtual line, face, & volume?? | teguhtf | ANSYS Meshing & Geometry | 2 | October 5, 2009 08:47 |