CFD Online Discussion Forums

CFD Online Discussion Forums (
-   ANSYS Meshing & Geometry (
-   -   [ICEM] Problems in mesh (

schuny October 8, 2011 11:47

Problems in mesh
I'm very new to ICEM CFD software. I'm moddleing a combustion chamber. The problem is how to create a new part as a volume(e.g. the clearence volume) instead of a surface and then make the volume mesh separately (e.g. the clearence volume and fluid)

Twix October 10, 2011 03:17

If You use blocking to generate the mesh put the blocks in new, separate part. If you use different meshing method You have to create material point.

All times are GMT -4. The time now is 12:49.