[ICEM] copy block

sasha1989 · February 8, 2017, 17:29

hey
im trying to copy the block (bottom up way) but while copying some of the block get the same number as the original one and then when e.g. deleting one of the copied, the original is also deleted (as is numbered the same way).
how to avoid the numbering issue?

Korayabi90 · February 11, 2017, 13:04

Hi,

Maybe it works. After you copy blocks apply this step;

Blocking > Check Blocks > Method: Run Check/Fix

I have experienced same problem. In this way I solved the problem.

I wish you good work.

sasha1989 · February 11, 2017, 17:54

hey
thanks for the response
i also think the renumbering can help - will try it too

February 8, 2017, 17:29	copy block	#1
sasha1989 New Member Join Date: Oct 2013 Posts: 6 Rep Power: 12	hey im trying to copy the block (bottom up way) but while copying some of the block get the same number as the original one and then when e.g. deleting one of the copied, the original is also deleted (as is numbered the same way). how to avoid the numbering issue?

February 11, 2017, 17:54	N+	#3
sasha1989 New Member Join Date: Oct 2013 Posts: 6 Rep Power: 12	hey thanks for the response i also think the renumbering can help - will try it too

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ICEM] copy block to many small cyliders in a grid	SPH_CFD	ANSYS Meshing & Geometry	2	November 28, 2016 16:11
[blockMesh] Inconsistent number of faces between block	CrisMoreira	OpenFOAM Meshing & Mesh Conversion	10	April 28, 2015 19:06
[blockMesh] Mixer mesh - negative volume problem	jadtwo	OpenFOAM Meshing & Mesh Conversion	2	November 6, 2014 16:37
foamLog not solving for Ux, Uy, Uz	aerospain	OpenFOAM Post-Processing	5	April 18, 2012 10:01
[Commercial meshers] Icem Mesh to Foam	jphandrigan	OpenFOAM Meshing & Mesh Conversion	4	March 9, 2010 02:58

February 11, 2017, 13:04		#2
Korayabi90 New Member Koray G. Join Date: Oct 2015 Location: Ankara/TURKEY Posts: 4 Rep Power: 10	Hi, Maybe it works. After you copy blocks apply this step; Blocking > Check Blocks > Method: Run Check/Fix I have experienced same problem. In this way I solved the problem. I wish you good work.