CFD Online Discussion Forums

CFD Online Discussion Forums (
-   ANSYS Meshing & Geometry (
-   -   [ANSYS Meshing] Defining BC on ICEM mesh (

Kafi_3 November 16, 2011 06:48

Defining BC on ICEM mesh
Please, I am a fresh CFD/CFX user. I created a 2D mesh in ICEM, and imported it into CFX-Pre with .cfx5 extension. When I tried to apply boundary conditions within the CFX-Pre, the names of my inlet and oulet do not show in the location list (under Basic Setting). I believe it's simple but I don't know how to get it done. Who can help please?

All times are GMT -4. The time now is 10:53.