[GAMBIT] Problem in importing in fluent

vaibhavraikhare · November 23, 2011, 13:09

i have made a design jus lyk an closed box...now have a prob that there is 1 plate inside the box and during importing fluent doesnt read that plate bcoz of 2D and 3D...
is there any way to change the plate in 3D design means my whole model is in green color that represent volume..but the plate color is ligt blue..that means its onlt a surface..hw could i change it into green color..

-mAx- · November 24, 2011, 03:09

you can create your volume by sweeping your blue surface.

vaibhavraikhare · November 24, 2011, 04:35

sorry max..didnt get ur point..the blue surface will not convert into volume bcoz its nt d close 1...its an open plate like a passage in the box.

-mAx- · November 24, 2011, 12:43

yes but if you want your surface to have a depth (volume), then you need to sweep your face
http://my.fit.edu/itresources/manual...mg0205.htm#406

If you want to stay with your thin plate, then consider it as baffle. (just enforce gambit to define it as wall)

November 23, 2011, 13:09	Problem in importing in fluent	#1
vaibhavraikhare Member Vaibhav Rai Khare Join Date: Jul 2011 Location: Jaipur Posts: 37 Rep Power: 14	i have made a design jus lyk an closed box...now have a prob that there is 1 plate inside the box and during importing fluent doesnt read that plate bcoz of 2D and 3D... is there any way to change the plate in 3D design means my whole model is in green color that represent volume..but the plate color is ligt blue..that means its onlt a surface..hw could i change it into green color..

November 24, 2011, 03:09		#2
-mAx- Super Moderator Maxime Perelli Join Date: Mar 2009 Location: Switzerland Posts: 3,297 Rep Power: 41	you can create your volume by sweeping your blue surface. __________________ In memory of my friend Hervé: CFD engineer & freerider

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
MPI problem with fluent	aryanet	FLUENT	17	October 30, 2017 21:04
problem importing mesh into gambit	tsm554	FLUENT	7	December 3, 2010 22:15
Problem about Fluent on Linux	hbinma	FLUENT	3	July 6, 2008 10:49
A problem about Importing mesh from fluent	aderliner	OpenFOAM Running, Solving & CFD	0	December 18, 2006 23:00
Problem using parallel Fluent	Gustavo	FLUENT	0	June 27, 2004 23:12

November 24, 2011, 04:35		#3
vaibhavraikhare Member Vaibhav Rai Khare Join Date: Jul 2011 Location: Jaipur Posts: 37 Rep Power: 14	sorry max..didnt get ur point..the blue surface will not convert into volume bcoz its nt d close 1...its an open plate like a passage in the box.

November 24, 2011, 12:43		#4
-mAx- Super Moderator Maxime Perelli Join Date: Mar 2009 Location: Switzerland Posts: 3,297 Rep Power: 41	yes but if you want your surface to have a depth (volume), then you need to sweep your face http://my.fit.edu/itresources/manual...mg0205.htm#406 If you want to stay with your thin plate, then consider it as baffle. (just enforce gambit to define it as wall) __________________ In memory of my friend Hervé: CFD engineer & freerider