CFD Online Discussion Forums

CFD Online Discussion Forums (
-   ANSYS Meshing & Geometry (
-   -   [ICEM] Interphase boundary condition (

SerSe December 1, 2011 08:17

Interphase boundary condition
Dear all,

I am modelling an air nozzle inside a pipe with 2D axisym geometry. To obtain nice mapped mesh, I have meshed the edges of the nozzle and assigned each of them a boundary condition. But if I use interphase BC for nozzle exit, I get errors in Fluent (Unassigned interphase zone detected). I would like that Fluent calculates variables at nozzle exit

Can anyone explain to me why I do get such error?
Should I remove the nozzle exit edge and work on mesh?

Thank you very much for your help


All times are GMT -4. The time now is 19:48.