CFD Online Discussion Forums

CFD Online Discussion Forums (
-   ANSYS Meshing & Geometry (
-   -   [ANSYS Meshing] multibody (

firatwsen December 11, 2011 15:25

Hi ;

I am trying to mesh 2 bodies. These two bodies have 5 parts also. I do not want to combine 2 bodies into one because mesihng geometry with two bodies is easier. But I have some problem. When I import mesh intofluent, there is a boundary condition which is assigned as wall but I want this BC to be interior. In addition, these wall is between two fluid regions so there seems to be no problem in changing to interior but I can not!!! Please help me otherwise I will be dismissed with my ms thesis.

With Regards

pstreufert December 12, 2011 13:21

The interior bc is for a volume, not a face, which is what a wall bc is. I think you need an interface between the two fluids on either side of the "wall".

firatwsen December 14, 2011 01:59

thanks for your help

kvloover December 14, 2011 19:12

I'm having the same issue (posted it in fluent subfolder)

But with the addition that I cannot select Interface.
It's formed a boundary together with the mirrored version and i can only select:

firatwsen December 15, 2011 14:51

i could not find any solution so i had to left that problem

firatwsen December 15, 2011 15:28

meshing multizone

I am trayinh to mesh a geometry using multizone meshing method. Firstly I am meshing geometry which is sweepable so I get a hex mesh. Then I continue with second body with multizone method. But when it creates mesh for second body, it removes the mesh generated at first body. Does any body knows the reason?

All times are GMT -4. The time now is 09:57.