 |
 |
 |
|
|
|
[Sponsors] | ||||
December 15, 2011, 14:32
|
multizone meshing
|
#1 |
|
New Member
BaBa-Firat
Join Date: May 2011
Posts: 11
Rep Power: 14  |
Hi
I am trayinh to mesh a geometry using multizone meshing method. Firstly I am meshing geometry which is sweepable so I get a hex mesh. Then I continue with second body with multizone method. But when it creates mesh for second body, it removes the mesh generated at first body. Does any body knows the reason? |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ANSYS Meshing] Migrating from GAMBIT to ANSYS Meshing | David-CFD | ANSYS Meshing & Geometry | 1 | April 1, 2011 05:22 |
| Information on Multizone meshing in ICEM | DarrenC | ANSYS Meshing & Geometry | 1 | April 21, 2010 16:27 |
| Meshing locks workbench window. | andy2o | CFX | 0 | February 1, 2008 05:01 |
| Singularity of grid?Volume meshing vs face meshing | Ken | Main CFD Forum | 0 | September 4, 2003 11:09 |
| Volume Meshing & Face Meshing? singularity of grid | ken | FLUENT | 0 | September 4, 2003 11:08 |
Linear Mode
