[octorisca]

first, i'm sorry because i can't speak english very well,
sorry if i can't use the grammer well,

oke,, i have my thesis and have to finish in 2 weeks,,
this is my UNSTRUCTURED geometry on ICEM, this is a flying car, with 2 rotor.



this is the surface mesh, the surface mesh is fine.. but not about volume mesh




but, i can't complete the volume mesh..
this is a comment from comment box. after the volume mesh.


and the "single edge near" was here.




i've been repair the geometry millions time.
but, there's no solution.

WHAT SHOULD I DO?
please help me,,
i'm desperate about that.
i'm sorry if my explanation was bad.

i need your help.. thanks..

[PSYMN]

Before attempting the volume mesh portion, run the checks... Particularly the check for single edges.

Create a subset from the single edge check.

Right click on subsets in the model tree and add a layer... Do this a couple times so you get an idea about what is going on around the two subsets.

Then inspect and solve your problem at a mesh editing level. It may be as simple as splitting an edge and then merging the opposing node with it... I can't tell because your image is zoomed out, but if you can't figure it out, just zoom in on each of the subsets (separately) and post a pic.

[Abdelkader_Aero]

hello octorisca i read late your message , send me your geometrie in .iges or .tin and the gometrie of far filed and in witch extention of mesh you want ( .mesh .....), i will do it for you , this is my Email aeronautique87@gmail.com