|January 5, 2012, 15:47||
Icem prism option is not selectable....
Join Date: Mar 2011
Posts: 50Rep Power: 8
Hi, I'm trying to build a prism mesh on the boundary layer of turbine. I have a pretty good tetra mesh file from fluent, with extension .msh
When I'm trying to generate prism mesh, the option is just grey and I can not select it. Can anyone help?
I'm new to meshing stuff.....
I get the geometric file from the mesh with Icem, then loaded the file.
Last edited by mingersai; January 5, 2012 at 19:02.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Wind turbine simulation||Saturn||CFX||45||February 8, 2016 05:42|
|Water subcooled boiling||Attesz||CFX||7||January 5, 2013 04:32|
|RPM in Wind Turbine||Pankaj||CFX||9||November 23, 2009 05:05|
|Simulation of a single bubble with a VOF-method||Suzzn||CFX||18||October 2, 2009 04:18|
|mass flow in is not equal to mass flow out||saii||CFX||2||September 18, 2009 08:07|