|
[Sponsors] |
January 17, 2012, 12:37 |
Writing Input File
|
#1 |
New Member
Kora
Join Date: Nov 2011
Posts: 11
Rep Power: 14 |
Hello. I've just finished a 2D aerofoil mesh on ICEM and want to export a mesh file for FLUENT on ANSYS workbench. I have set the output solver as "Fluent_V6" and common strucutral solver as "ANSYS", then I set the BC. Next I clicked onto the write input button, but realise that it has to save on an already existing .uns file. I used to use GAMBIT and all I needed to do was just save. How does this work in ICEM??
|
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Other] mesh airfoil NACA0012 | anand_30 | OpenFOAM Meshing & Mesh Conversion | 13 | March 7, 2022 17:22 |
[swak4Foam] swak4foam building problem | GGerber | OpenFOAM Community Contributions | 54 | April 24, 2015 16:02 |
Installation of OpenFOAM-1.6 on Ubuntu 9.10 | marval | OpenFOAM Installation | 2 | March 17, 2010 08:33 |
OF 1.6 | Ubuntu 9.10 (64bit) | GLIBCXX_3.4.11 not found | piprus | OpenFOAM Installation | 22 | February 25, 2010 13:43 |
[OpenFOAM] Paraview command not found | hardy | ParaView | 7 | September 18, 2008 04:59 |