|
[Sponsors] |
[ICEM] Very simple problem encountered by a begineer |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
February 7, 2012, 15:28 |
Very simple problem encountered by a begineer
|
#1 |
Super Moderator
Ghazlani M. Ali
Join Date: May 2011
Location: Tokyo, Japan
Posts: 1,385
Blog Entries: 23
Rep Power: 28 |
hello everyone,
I'm new to icem. Here is my problem: when i draw 4 points, put edge between them to create a square, and to create a block. The block come out of the limit of the edges in the right (see picture) what can be the problem. Thanks you in advance Cheers, Ali |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Very simple natural convection problem | Naseem | FLUENT | 19 | December 17, 2020 17:00 |
[Technical] General meshing-question for simple (thermal) problem | suitup | OpenFOAM Meshing & Mesh Conversion | 2 | July 26, 2012 20:45 |
How can i get the static pressure in a simple problem? | tofighi | FLUENT | 1 | September 27, 2011 11:45 |
Simple Meshing Problem with Gambit | Mario | FLUENT | 4 | April 18, 2003 10:52 |
? Simple CFD problem | Davy | Main CFD Forum | 0 | August 21, 1998 07:19 |