Question about Formatted Point Data
Hello, all, thanks for reading this,
I was making a binary tree structure, and I managed to write a MATLAB writer that brings the tree into ICEM CFD via the formatted point data input, but I have a question. Is it possible to build cylinders through this input as well? Basically, I have it so it continually writes curves for two points (but no surfaces because I don't need b-splining for a binary tree). In other words, I can build the 2-D trees, but I also want to build 3-D cylinders on the 2 points as well. Is this possible? Thanks! |
All times are GMT -4. The time now is 14:29. |