 |
 |
 |
|
|
|
[Sponsors] | ||||
March 3, 2012, 09:32
|
3 Bladed VAWT mesh
|
#1 |
|
New Member
Callum
Join Date: Jan 2012
Posts: 3
Rep Power: 14  |
Hi, I'm trying to create a 120 degree mesh for one of the 3 blades. I've tried forming the mesh from some ICEM Hexa Meshing videos on youtube, although these have been helpful, i have little knowledge when it comes to meshing and i'm not sure how to adapt it to my problem. I want it to look similar to the image attached. Although i've created a crude geometry for the mesh field using points and lines, when it comes to blocking the results are frankly hideous. Would be very grateful to anyone who can be me any guidance.
Thank you |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ICEM] surface mesh merging problem | everest | ANSYS Meshing & Geometry | 44 | April 14, 2016 06:41 |
| Meshing aifoil in ICEM | student123a | ANSYS Meshing & Geometry | 13 | December 8, 2010 10:40 |
| VAWT mesh in gambit | Jonathan | Main CFD Forum | 4 | January 22, 2009 08:18 |
| 2d irregular grid | Remy | Main CFD Forum | 1 | December 22, 2008 04:49 |
| basic of mesh refinement | arya | CFX | 4 | June 19, 2007 12:21 |
Linear Mode
