[ICEM] Wing Trailing Edge Prism and prism width -- CFD Online Discussion Forums

March 4, 2012, 10:31

Wing Trailing Edge Prism and prism width

srad

New Member

tetsuya

Join Date: Dec 2011

Posts: 3

Rep Power: 16

Hi, everyone.
1.I wanna make Prism width on the trailing edge(red circled).
2.If I can, I wanna make all the prism width(red line)smaller.

Can anyone tell me how?

Best Regards.

Attached Images

Untitled.jpg (36.0 KB, 32 views)

March 7, 2012, 04:44		#2
energy382 Senior Member Christoph Join Date: May 2011 Location: Germany Posts: 182 Rep Power: 19	--> Tutorials

March 12, 2012, 10:10		#3
srad New Member tetsuya Join Date: Dec 2011 Posts: 3 Rep Power: 16	Sorry, you now the URL?

« Previous Thread | Next Thread »

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
ICEM - problems with prism mesh	João Lourenço	CFX	2	September 18, 2019 04:07
Getting prism to inflate into mixed tet-hex meshes	Joe	CFX	16	October 10, 2011 08:06
[ICEM] Improve prism mesh at trailing edge	siw	ANSYS Meshing & Geometry	5	August 21, 2011 00:56
[ICEM] prism problem	zkdkeen	ANSYS Meshing & Geometry	5	December 2, 2009 21:54
Icemcfd: Preventing prism inflation collisions?	Joe	CFX	1	July 31, 2007 10:13

All times are GMT -4. The time now is 20:57.