[DesignModeler] Windows7, showing constraints while drawing

stefke · March 5, 2012, 12:19

I made a full installation of ANSYS14.0 on a 32bit windows7 Pc. When sketching in DesignModeler, the constraints are not shown (character P for point selection or C for point on axis, H or V). The check boxes for viewing constraints are set. I have the impression that it is related to some general settings of the PC outside ansys.
Is there a way around?

evcelica · March 6, 2012, 18:58

I had the same thing happen on an older Dell computer with 12.1 64 bit. I never did fix it, so I can't help you as to why, sorry.
If anyone does know how that would be great.

stefke · March 7, 2012, 02:33

Thank you for this reply. It is indeed a Dell PC, but not that old. Also our support is looking at it but couldn't find a fix until now...

ing marin cfd · February 22, 2018, 12:23

Hello, first of all this constrains appears only in sketch mode, try this: in DM click on tools - Options - Sketching - cursor auto constrains, turn off and ok, then follow the same steps but this time turn On cursor auto constrains. I hope this solves your problem.

March 5, 2012, 12:19	Windows7, showing constraints while drawing	#1
stefke New Member Join Date: Mar 2012 Posts: 2 Rep Power: 0	I made a full installation of ANSYS14.0 on a 32bit windows7 Pc. When sketching in DesignModeler, the constraints are not shown (character P for point selection or C for point on axis, H or V). The check boxes for viewing constraints are set. I have the impression that it is related to some general settings of the PC outside ansys. Is there a way around?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Drawing Contours without showing mesh	tolu	FLUENT	13	May 18, 2011 16:54
What a Strange Drawing in GAMBIT...	teguhtf	ANSYS Meshing & Geometry	3	October 5, 2009 11:17
drawing of contour plots	chinthakindi	Main CFD Forum	1	April 27, 2004 04:33
Limit in Number of Simple Constraints	Luis Rojas-Solorzano	CFX	6	September 18, 2002 09:30
Advanced Constraints	Sudarshan Kumar	CFX	2	November 7, 2000 12:56

March 6, 2012, 18:58		#2
evcelica Senior Member Erik Join Date: Feb 2011 Location: Earth (Land portion) Posts: 1,167 Rep Power: 23	I had the same thing happen on an older Dell computer with 12.1 64 bit. I never did fix it, so I can't help you as to why, sorry. If anyone does know how that would be great.

March 7, 2012, 02:33		#3
stefke New Member Join Date: Mar 2012 Posts: 2 Rep Power: 0	Thank you for this reply. It is indeed a Dell PC, but not that old. Also our support is looking at it but couldn't find a fix until now...

February 22, 2018, 12:23		#4
ing marin cfd New Member Anibal Marin Join Date: Feb 2018 Posts: 1 Rep Power: 0	Hello, first of all this constrains appears only in sketch mode, try this: in DM click on tools - Options - Sketching - cursor auto constrains, turn off and ok, then follow the same steps but this time turn On cursor auto constrains. I hope this solves your problem.