CFD Online Discussion Forums

CFD Online Discussion Forums (
-   ANSYS Meshing & Geometry (
-   -   [DesignModeler] Airfoil generation issue (

micro11sl March 12, 2012 07:13

Airfoil generation issue
1 Attachment(s)
Hi, is there anyone ever using Design Modeler to import data points and generate the airfoil for 2D analysis?

The tutorial from Cornel that many people refer to, , has an issue with the airfoil trailing edge.

Even following exactly the steps in the tutorial, I got a "rounded" trailing edge rather than a sharp one after projection, as shown in the attachment.

The curve of the airfoil was generated successfully, but the projected edge smooth the sharp angle at the trailing edge automatically. Anyone experienced this? And any ideas?


gmd March 15, 2012 17:09

I'm pretty sure it will become sharp once imported into the meshing program.

All times are GMT -4. The time now is 18:51.