[DesignModeler] Recurring solids and automatic naming

chh · March 20, 2012, 20:25

Hello!

As I'm relatively new to ANSYS I got some questions on the feasability of a planned project.

For my analysis I have to create a geometry containing a considerable number of geometrically identical solid bodies w/ different thermal properties.

For their creation I used the pattern function, which works quite fine.

Now I'm wondering if there's any way to automatically name the solids e.g. as "box 1, box 2, etc" and even to generate the (thermal) interfaces between them.

Is there any way to write a script for Design Modeler?
I'm using the academich ANSYS 13.0 version.

Thank you so much for your suggestions!

rikio · March 20, 2012, 22:25

After overviewing the Help, I think there should be a way to achieve what you want. But I never tried this, so looking forward the solution as well, with you

.

March 20, 2012, 20:25	Recurring solids and automatic naming	#1
chh New Member Christian Huber Join Date: Mar 2012 Posts: 1 Rep Power: 0	Hello! As I'm relatively new to ANSYS I got some questions on the feasability of a planned project. For my analysis I have to create a geometry containing a considerable number of geometrically identical solid bodies w/ different thermal properties. For their creation I used the pattern function, which works quite fine. Now I'm wondering if there's any way to automatically name the solids e.g. as "box 1, box 2, etc" and even to generate the (thermal) interfaces between them. Is there any way to write a script for Design Modeler? I'm using the academich ANSYS 13.0 version. Thank you so much for your suggestions!

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
mass flow in is not equal to mass flow out	saii	CFX	12	March 19, 2018 05:21
Simulation of a single bubble with a VOF-method	Suzzn	CFX	21	January 29, 2018 00:58
Water subcooled boiling	Attesz	CFX	7	January 5, 2013 03:32
No results for solid domain	Gary Holland	CFX	10	March 13, 2009 03:30
Two-Phase Buoyant Flow Issue	Miguel Baritto	CFX	4	August 31, 2006 12:02

March 20, 2012, 22:25		#2
rikio Senior Member Rikio Join Date: Mar 2009 Location: SH, China Posts: 182 Blog Entries: 1 Rep Power: 17	After overviewing the Help, I think there should be a way to achieve what you want. But I never tried this, so looking forward the solution as well, with you .