 |
 |
 |
|
|
|
[Sponsors] | ||||
March 27, 2012, 09:56
|
free surface flow
|
#1 |
|
New Member
Alexander
Join Date: Dec 2009
Location: Saint-Petersburg
Posts: 29
Rep Power: 16   |
Hello all!
I'm new in icem. May be my problem is trivial. I try to simulate the flow past the vessel in OpenFOAM. I need to get a good resolution of the grid near the interface between air and water. I created free surface plane and split the volume to two parts above free surface and low. . I produced unstructured mesh. But I've got a lot of bad quality elements in intersection of hull and free surface plane. Is it possible to edit them? What way is preferable?.  
Last edited by Svensson; March 29, 2012 at 05:34. |
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Thermocapillary free surface flow | zakifoam | OpenFOAM Running, Solving & CFD | 10 | December 12, 2016 11:44 |
| free surface flow past cylinder | vineet | FLUENT | 1 | February 21, 2011 23:11 |
| CFX gravity driven free surface flow tutorial | mechovator | CFX | 37 | July 27, 2009 10:28 |
| free surface flow in non-inertial reference frame | Tiedingg | FLOW-3D | 1 | February 26, 2009 19:51 |
| Free surface flow simulation question | Jane Luo | FLUENT | 1 | April 23, 2004 04:26 |
Linear Mode
