I tried but did not work. It seems I am going wrong at giving BCs. Please try extruding that mesh with 0.19 spacing and 32 layers.

Please give me directions to work on 3D mesh. Please its urgent.

Going to upload two videos (two parts for each and in total four) on youtube today. Worked on both files i.e. attached in this thread and as well as older one.

You can use y-block for sharp corners http://www.cfd-online.com/Forums/ans...tices-why.html

This may also be helpful
http://www.cfd-online.com/Forums/ans...id-y-grid.html

@ mahi007: In response to mahi007 queries and converted 2-d cylinder (from old) to 3d cylinder.

Old 2-d files: http://www.4shared.com/rar/LRL3929E/..._complete.html
New 3d files: http://www.4shared.com/zip/_cQL4Sm6/...r_3d_mahi.html


PartI
http://www.youtube.com/my_videos_edi...id=jL2hHxpsrHQ

Part II
http://www.youtube.com/watch?v=1lRRg...ature=youtu.be

2d to 3d
 

Refer to post #1

Procedure to convert 2d blocking and geometry into 3d blocking and geometry

2d files (same as posted on post#1) :http://www.4shared.com/zip/njICQ_NM/...thdomains.html

3d files :http://www.4shared.com/rar/A0xrmLf_/Cylinder3d.html



You tube links:

Part I :
http://www.youtube.com/my_videos_edi...id=l-Tz6MHlT1M

Part II :
http://www.youtube.com/watch?v=cWuVV...feature=relmfu

Thanks for the hint. I've already tried Y-blocking but it's not working...:(
Anyway, the blocking in this geometry looks good. This is just a minor problem.

Y-block works for wedge, I am sure you know it. Post pics to identify the problem area.

Here is one picture and I also added the .tin + prj. + blk. + .fbc files. When you apply the quality-criterion Det 3x3x3 at the pre-mesh you will see the region with the bad elements.