CFD Online Discussion Forums

CFD Online Discussion Forums (
-   ANSYS Meshing & Geometry (
-   -   [ICEM] Exporting node sets from ICEM CFD (

automation April 4, 2012 23:44

Exporting node sets from ICEM CFD
Hello everyone!!
I want to export all the node sets that I have created and have to import them into Abaqus. Now, in order to do this, I first open the .prj file, then I set the solver as Abaqus, accept all the parameters and boundary conditions, and finally write the Abaqus input file.
But the problem is that the ICEM CFD does not write all the node sets into the .inp file. What do I do?
Is there any other way to export the node sets?

Thank you!

luke1208 September 7, 2012 14:47

Any luck with getting all of the nodes written? I am having the same problem.

Thanks in advance!

All times are GMT -4. The time now is 01:14.